Find out
These are the most common questions we receive, perhaps your question will be resolved here.
If not, please contact us using the form on the Contact page.
General doubts
That depends on the characteristics of your installation. Sometimes it is enough to install equipment at the end of the hot water hydraulic line, so that all bathrooms have, at least in their main branch, hot water available. A certified installer could review the details and inform you of the best technical solution for your specific case. We can also help you on the technical support line.
No, it takes the cold water out of the hot pipe and returns it to the cold water pipe. It is a recirculator, not a heater.
On the contrary, its consumption is very low: 11watts/.92Amp
No, gas consumption is the same, but in addition to water, it saves time and money.
A button is pressed that starts the internal motor at 12 Volts, removing cold water from the hot water pipe, coming from the heater, and returning it to the cold water pipe. Once hot water reaches the HydroLoop®, the button light will turn off and the thermostat will send the “off” signal to the motor. Now you can open the tap and hot water will come out in a few moments. In case the heater is off or there is air in the pipe, the equipment timer will automatically turn off the engine after twelve minutes (adjustable).
No, since the pump is not to propel the water overcoming the pressure in the pipe, but rather to recirculate the water in the system, without changing the pressure. It should be installed under a sink or kitchen sink.
Of course! In some cases shipping will be free, depending on our distribution network and your location. If not, we will quote shipping using the zip code you provide us.
Bank transfer, credit or debit card, and if you are at authorized points of sale, also in cash.
Approximately 1400 grams.
Of course! If you take into account that more than 50% of a home’s consumption occurs in the shower, that a shower can last around 8 minutes, and that the average time for hot water to reach the shower is 3 to 4 minutes, you will be saving at least 10% of your monthly consumption. It’s usually more than that.
That’s right, in fact, through the Polytechnic University of Querétaro, with whom we are working hard as a team, we are establishing strict rules of which we are references, for this type of technology.
Similar, yes, not the same. The purpose is the same but they achieve it in different ways. What is certain is that they are more expensive (partly because they are imported) and more complex to install. Without a doubt we are the best option!
The easiest way is online, although you can choose a distributor who will physically deliver it to you, if it is close to you.
Equipment
A button is pressed that starts the internal motor at 12 Volts, removing cold water from the hot water pipe coming from the heater, and returning it to the cold water pipe. Once hot water reaches the hydroloop, the button light will turn off and the thermostat will send the “off” signal to the engine. Now you can open the tap and hot water will come out in a few moments. If the heater is off, or there is air in the pipe, the equipment timer, at twelve minutes (adjustable), will automatically turn off the engine.
That depends on the characteristics of your installation. Sometimes it is enough to install equipment at the end of the hot water hydraulic line, so that all bathrooms have, at least in their main branch, hot water available. A certified installer could review the details and inform you of the best technical solution for your specific case. We can also help you on the technical support line.
Approximately 1400 grams.
No, it takes the cold water out of the hot pipe and returns it to the cold water pipe. It is a recirculator, not a heater.
On the contrary, its consumption is very low: 11watts/.92Amp
No, because the pump is not to propel the water, overcoming the pressure of the pipe, but to recirculate the water in the system, without changing the pressure. It should be installed under a sink or kitchen sink.
That’s right, in fact, through the Polytechnic University of Querétaro, with whom we are working hard as a team, we are establishing strict rules of which we are references, for this type of technology.
Similar, yes, not the same. The purpose is the same but they achieve it in different ways. What is certain is that they are more expensive (partly because they are imported) and more complex to install. Without a doubt we are the best option!
Benefits
Of course! If you take into account that more than 50% of a home’s consumption occurs in the shower, that a shower can last around 8 minutes and that the average time for hot water to reach the shower is 2 and a half minutes, You will be saving at least 10% of monthly consumption. It’s usually more than that.
On the contrary, its consumption is very low: 11watts/.92Amp
No, it takes the cold water out of the hot pipe and returns it to the cold water pipe. It is a recirculator, not a heater.
No, gas consumption is the same, but in addition to water, it saves time and money.
That’s right, in fact, we are establishing strict rules of which we are references, for this type of technology.
Payments
Bank transfer, with credit or debit card, and if you are at authorized points of sale, also in cash.
La manera más sencilla es en línea, aunque puedes elegir algún distribuidor que te lo entregue físicamente, si está cerca de ti.
Can't find the answer?
If you do not find the answer to your question in this section, contact us using the form on the Contact page and we will be happy to assist you.
Get your Hydroloop today!
It’s very easy, buy it online
with your credit or debit card and receive it at your home.
